0 comments / Posted on by omg beautyhair

The reason why wigs become harder may be caused by improper use of care.


Do not care for a long time to cause wig hair, hard. It is recommended to use a special wig solution to prevent static electricity.

Caused by dyeing, the wig can not be burnt and can not be dyed.

Pull hard to break the structure of the wig. When the hair is knotted or crimped, do not pull it hard.

Steam with steam and steam without steam. Use a hot towel and slowly comb carefully.

Usually put on the hair set model when not wearing.

Care and maintenance:

Try not to get close to the high temperature, because the material relationship wig is not high temperature (except for the high temperature wire).

Chemical fiber wigs can't be dyed. If you need to trim, you can ask a professional stylist to trim the hair.

The combing action should be light. The wig sleeve should be combed before use. After putting on the wig, it can be combed a little. To comb the wig, it is better to use a relatively thin comb. When combing the wig, the method of oblique side combing should be adopted, and the straight combing is not possible, and the action is light.

Do not use hair clips. In order to prevent the wind from blowing the wig, some people like to use a hair clip to hold the wig. However, the clip should not be used too hard. Otherwise, it is easy to smash the wig of the wig. Therefore, it is best not to use a hair clip, you can use a decorative hair band to fix the hair on the wig.

It is normal to have a small amount of hair loss during the finishing process.

Usually, if you don't wear it, put it in the original packaging. When you take it, you can restore it as soon as you take it.

The wig can be tied up, but it can't be too high or the real hair will run out.

When you have a long wig comb, you should divide the wig into several sections and comb it from bottom to top. Be sure to be light and patient.

If the wig is not combed for a long time, do not pull it hard. You should spray a special non-oily maintenance liquid for the wig and then slowly and carefully open it.

Be careful not to spray the styling agent such as gel water or hair wax on the wig to make the wig sticky.

Use a non-oily maintenance solution for wigs (the method of use is also very simple: gently spray a few times on the wig before taking it) to make the wig soft and bright and prevent static electricity, so that the wig stays moisturized just like The same when buying back.

Wig cleaning:

Try not to get close to high temperatures, because the material is not resistant to high temperatures.

Most wigs can be dyed, and if you need to trim, ask a professional stylist to trim the hairstyle.

False hair is usually washed once every 1-2 months.

Wash with cold water or warm water. When washing, use normal shampoo. OK, it can be combined with general hair conditioner.

Wash the fake hair as much as possible without using a high-temperature wind such as a hair dryer. Use a dry towel to gently absorb excess water from the fake hair and put it in a ventilated place to avoid damage to the fake hair caused by direct sunlight.

Do not comb the fake hair immediately after washing, and wait for the fake hair to dry before combing.

Use combs for fake hair (commercially available in the store) can not be combed with a plastic comb.

Rolling hair basically does not use a comb, and the place where the roll is taken can be finished by hand.



Leave a comment

All blog comments are checked prior to publishing